Memory Operation; Memory Storage; Memory Channel Recall - Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual

The memory system of the FT
mode, and a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory
Groups, and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank)
memories.
1. Set the VFO-A up with all frequency, mode, and sta-
tus the way you want to have it stored.
2. Press the A M button (#
rent channel number will start blinking); the contents
of the current memory channel will be shown on the
VFO-B display field.
3. Press the MCH/GRP key (#
When you press the MCH/GRP key, the Red LED
imbedded within the switch should light up, indicat-
ing that you are ready to choose a channel into which
to store the data.
Advice
If the Red LED imbedded in the MCH/GRP switch does
not light up, check to be sure that the orange lamp to the right
of the CLAR/VFO-B knob (#
press the A/B switch to make it go out, then press the MCH/
GRP] key again.
4. Rotate the CLAR/VFO-B knob (#
memory channel onto which you wish to store the data.
If you have selected a channel on which data is al-
ready stored, that frequency will appear on the VFO-
B's frequency display field.
5. Press and hold in the A M key for two seconds to
store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the A M key in long enough.
1 Press the V/M switch (#
the Memory mode. A memory channel number will
appear in the multi-panel window.
2. Press the MCH/GRP key (#
The Red LED inside the switch will light up, indicat-
ing that you are ready to recall a memory channel.
Advice
If the Red LED imbedded in the MCH/GRP key does not
light up, check to be sure that the orange lamp to the right of
the CLAR/VFO-B knob (#
the A/B switch (#
MCH/GRP key again.
3. After pressing the MCH/GRP key, you may rotate
the CLAR/VFO-B knob (#
memory channel.
Advice
To work within a particular Memory Group, press and hold
in the MCH/GRP key for two seconds. The imbedded
LED will glow Orange; now press the MCH/GRP key
momentarily, and the LED will change to Red; you many
now choose the channel within the selected Memory Group.
FT 9000 C
DX ONTEST
9000 Contest allows storage and recall of up to 99 memories, each storing frequency,
DX
M
EMORY
) momentarily (the cur-
) momentarily.
) is not illuminated. It is,
) to select the
M C
EMORY
), if necessary, to enter
) momentarily.
) is not illuminated. It is, press
) to make it go out, then press the
) to select the desired
O M
PERATION ANUAL
M
EMORY
S
TORAGE
R
HANNEL ECALL
O
PERATION
A M key
V/M key
MCH/GRP switch
CLAR/VFO-B knob
V/M key
MCH/GRP switch
CLAR/VFO-B knob
Page 99