Checking A Memory Channel's Status; Erasing Memory Channel Data - Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual

M O
EMORY
Before programming a channel into memory, you can check the current contents of that channel without the danger of
over-writing the data accidentally.
1. Press the MCH/GRP key (#
The imbedded LED will glow Red, indicating that
you are now ready to view memory channel con-
tents.
Advice
If the Red LED imbedded in the MCH/GRP key does not
light up, check to be sure that the orange lamp to the right of
the CLAR/VFO-B knob (#
the A/B switch to make it go out, then press the MCH/
GRP key again.
2. Press the A M key (#
The data stored in the currently-selected memory
channel will be displayed in the VFO-B frequency
field. However, since you are only checking the con-
tents of the memory channel, your radio will not
have moved to the memory channel's frequency.
3. Rotate the CLAR/VFO-B knob (#
other memory channels. To exit from the Memory
Check mode, press the A M key once more.
1. Press the MCH/GRP key (#
imbedded LED will glow Red, indicating that you are
now ready to view memory channel contents.
Advice
If the Red LED imbedded in the MCH/GRP key does not
light up, check to be sure that the orange lamp to the right of
the CLAR/VFO-B knob (#
the A/B switch to make it go out, then press the MCH/
GRP key again.
2. Press the A M key (#
The data stored in the currently-selected memory chan-
nel will be displayed in the VFO-B frequency field.
3. Rotate the CLAR/VFO-B knob (#
memory channel that you would like to erase.
4. Press the LOCK switch (#
of the selected memory channel.
Advice
After erasure, only the memory channel number will
remain; the frequency data will disappear from the
display.
If you make a mistake and wish to restore the memory's
contents, just repeat steps (1) through (3) above.
Page 100
PERATION
M C
EMORY HANNEL

Checking a Memory Channel's Status

) momentarily.
) is not illuminated. It is, press
).
) to select
E M
RASING EMORY
) momentarily. The
) is not illuminated. It is, press
).
) to select the
) to erase the contents
R
ECALL
Advice
While the Memory Check function is engaged, the
memory channel number will blink.
While operating in the VFO mode, using Memory
Check, you may store the current contents of the VFO
into the selected memory by pressing and holding in
the A M key for two seconds (until the double
beep). Conversely, if you wish to write the contents
of the current memory into the VFO-A register, press
and hold in the M A key (#
C D
HANNEL ATA
FT 9000 C
DX ONTEST
switch
MCH/GRP switch
CLAR/VFO-B knob
) for two seconds.
LOCK switch
switch CLAR/VFO-B knob
O M
PERATION ANUAL