Konica Minolta bizhub 181 User Manual page 298

When a message appears
Message
Paper Empty
NO SUITABLE PAPER
LOAD PAPER (#XXX)
APS SIZE ERROR (#XXX)
AMS SIZE ERROR
PAPER SIZE ERROR
RESET PAPER (#XXX)
MEMORY FULL
(PRESS ANY KEY)
MEMORY FULL
ADMIN STRATOR
(PRESS ANY KEY)
bizhub 181
Cause
(when specifying copy settings)
The selected paper drawer
contains no paper.
"#" indicates the paper drawer,
and "XXX" indicates the paper
size.
• The paper size setting for the
selected paper drawer was
changed while copying.
• While copying with the
"Mixed Original" setting and
the "AUTO" Paper setting
selected, paper of a suitable
size cannot be found. "#" in-
dicates the paper drawer,
and "XXX" indicates the pa-
per size.
While copying with the "AUTO"
Paper setting selected, paper
of a suitable size cannot be
found.
While copying with the "AUTO"
Zoom setting selected, the
combination of the document
and paper sizes caused the
zoom ratio to exceed the range
between 25% and 400%.
The paper loaded in the paper
drawer caused a size error. "#"
indicates the paper drawer, and
"XXX" indicates the paper size.
The size of the data for the
scanned image has exceeded
the capacity of the memory.
The image data received from
the computer has exceeded
the capacity of the memory.
Remedy
Either load paper of the speci-
fied size into the specified pa-
per drawer, or press the [Paper]
key and select a different paper
size.
Either load paper of the speci-
fied size, or press the [Paper]
key and select a different paper
size.
Either load paper of a suitable
size, or press the [Paper] key
and select a different paper
size.
Either load paper of a suitable
size, or press the [Zoom] key
and select a different zoom ra-
tio.
For a paper feed unit, remove
the loaded paper, and then re-
load the paper according to the
procedure described in "Load-
ing paper" on page 3-8. For pa-
per of a non-standard size,
refer to "Copying onto label
sheets" on page 4-37. For a by-
pass tray, remove the loaded
paper, and then reload the pa-
per according to the procedure
described in "Loading plain pa-
per into the bypass tray" on
page 4-17. For paper of a non-
standard size, refer to"Copying
onto manually fed paper (man-
ual bypass tray)" on page 4-27.
Press any control panel key, or
turn the machine off, then on
again. (The scan data should
be cleared from the memory.)
Press any control panel key, or
turn the machine off, then on
again. (The received image
data should be cleared from
the memory.)
7
7-27