Section 3 - Basic Operations; About The Rp-7 Valve's Modes; Program Mode; Bank Mode - DigiTech RP-7 VALVE User Manual

Section -3 Basic Operations

Section 3 - Basic Operations

About the RP-7 Valve's Modes

The RP-7 Valve offers seven modes, allowing easy operation of the Effects and Parameters. The modes are as follows:

PROGRAM MODE

Allows you to scroll through the 40 Factory and User Programs by using the <UP> and <DOWN> buttons as well as the <UP>
and <DOWN> foot switches. Enter Program mode by pressing the <UP> and <DOWN> foot switches simultaneously until the Program LED
lights and a P appears briefly in the display window. Foot switches <1-4> act as on/off toggle switches for the specified effects.

BANK MODE

Allows you to scroll quickly through Factory and User Banks by using the <UP> and <DOWN> foot switches. Enter Bank mode by pressing
the <UP> and <DOWN> foot switches simultaneously until the Bank LED lights and a
enter Bank mode, the Bank and Program numbers from the previous mode will be retained. When a Program number is displayed in the
display window, you can use the Value <UP> and <DOWN> buttons to scroll through Programs and Banks, exactly like Program mode.
When the <UP> and <DOWN> footswitches are used in Bank mode, you will scroll through Banks only. When you change a Bank using this
method, the previous Program number is not displayed with the new Bank. The LEDs above foot switches <1-4> will begin flashing, indicating
that you can choose a Program in the selected Bank by pressing one of the four foot switches. Once a Program number has been selected, both
the Bank and Program numbers will be displayed. Exit Bank mode by changing to another mode.

EDIT MODE

Allows you to modify effect Parameters in a Program. Enter Edit mode by pressing the <EDIT> button. The Display window now shows the
value of the Parameter indicated by the LEDs in the Matrix. You can scroll through the Parameter matrix using the Parameter Select buttons.
The <UP> and <DOWN> buttons allow you to scroll through the vertical Parameter LEDs, while the <LEFT> and <RIGHT> buttons allow
you to scroll through the horizontal Effect LEDs.
After selecting a Parameter, you can scroll through its values with the <UP> and <DOWN> Value buttons. When changing Parameter values, a
decimal point will flash in the display when the value is not the stored value for the program. The Store LED will light at this time as well. If
you return to the original value, the decimal point will stop flashing and the Store LED will go off. If you exit Edit mode after changing the
Parameters and then return to Edit mode, the last viewed Parameter will be displayed.

STORE MODE

Once you have modified the Parameters and Effects, you can store them to a user Program location. When you change an Effect or Parameter in
a Program, the Store LED will light, indicating that you have changed a Parameter and need to store the changes. Press the <STORE> button
once and the first seven segment LED in the Display window will flash U. Select the User Bank and Program location you want to store your
changes to, and press the <STORE> button again to save the changes.
8
RP-7 Valve
B appears briefly in the display window. When you
User Guide