Preamp - DigiTech RP-7 VALVE User Manual

RP-7 Valve

Preamp

Parameters
On/Bypass
Type
Gain
On Level
Off Level
The distortion section of the RP-7 Valve has six extremely flexible distortion types, capable of producing the smoothest of the blues tones to
the full shred gain of a cranked up stack.
On / Bypass
Type
Gain
On Level
Off Level
User Guide
Displayed Values
O n - b y p
C L N 1 - C L N 2 - B l u e - S A T - o d r - G r u - H s t n - F u 2 2
1 . . . 1 1
- o o . . . 1 2
- o o . . . 1 2
Turns the Preamp on or off.
Selects the type of preamp voicing used. CLN1 is a warm clean tube tone, CLN2 is a bright clean tube
tone, BLUE is a bluesy distortion with moderate gain, SAT is a high gain tube distortion which is ideal
for soloing. On the solid state side, odr is a low to medium gain distortion, and Gru is an over the top
high gain distortion, HStn is a warm sustaining distortion, and FuZZ is a vintage full-frequency fuzz.
Controls the amount of distortion produced by the RP-7 Valve. High settings produce greater gain and
drive for effortless soloing, while low settings offer better nuance and dynamic control. Ranges from 1 to
11.0.
Note: The Gain control parameter is not available in CLN 1 and CLN 2 preamp types.
Sets the output level of the Distortion while the effect is ON. Ranges from -∞ to 12.
Sets the output level of the Distortion while the effect is OFF. Ranges from -∞ to 12.
Section - 4 Effects and Parameters
11