DigiTech JAMMAN STEREO Owner's Manual page 17

Aux Input (Finish) LED
This LED indicates the Aux Input is selected for recording (see page
34). When the Shift button is enabled, this LED will light when the
"Finish" stop mode is selected for the Loop.
Center – (Fade) LED
This LED lights when the Aux Input is selected for recording with
the Center – (center minus) option applied (see page 34). When
the Shift button is enabled, this LED will light when the "Fade" stop
mode is selected for the Loop.
Full Range Amp LED
This LED lights when the Aux Input is selected for recording. The
program material will be recorded with an equalization curve so that
when it is played through a guitar amp it will more closely retain its
original frequency response (see page 34).
Record Mode (Stop Mode) Button
10.
Press this button to select the inputs that are to be recorded: Inst/
Mic or Aux Input with options of "Center Minus" and/or Full Range
Amp (indicated by the LEDs next to the button).
Press this button while the Shift button is lit to select one of three
Stop Modes: Stop, Finish, or Fade, indicated by the LEDs next to the
button (see page 36).
Auto Record (Loop/Single) Button
11.
Press this button to enable Auto Record for all empty loop
memories. When Auto Record is enabled, you can arm the JamMan
Stereo to record but recording only starts when you begin playing
(see page 26).
Guided Tour - Front Panel
®
13