Recording Overdubs - DigiTech JAMMAN STEREO Owner's Manual

Recording Overdubs

Once a loop phrase is recorded, you can add overdubs over the top of it.
Overdubs can only be recorded to Loop phrases and not to Single phrases.
1. Use the
a previously recorded Loop phrase, or use a newly recorded phrase
that has not yet been stored. The
recorded phrase is selected. If the
selected a loop on the optional memory card.
2. Press the
status LEDs will light solid green and the phrase will begin playing.
3. Press and release the
overdub recording. This footswitch and the
now light solid yellow and any audio introduced on the selected input
will be added to the audio the playback.
4. When you have an overdub you are happy with, press the
Rec/PLaY/oVeRDUb
playback (this footswitch and the
You can continue adding overdubs by continuing to press the
footswitch. Each time an overdub is added, the last overdub is
oVeRDUb
merged with the original loop and it can no longer be undone using the
Undo functions (see page 32).
Once you are finished with overdubbing, press the
stop playback/overdubbing.
NOTE: Changing loops discards any overdubs that have not been stored to
memory. Storing overdubs will remove the ability to undo or clear overdubs.
30
knob or the
seLect
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
footswitch to disable overdubbing and continue
LooP UP/LooP DoWN
LED must be lit if a previously
LooP
caRD MeM
footswitch. This footswitch and the
footswitch again to begin
oVeRDUb
status LEDs will light solid green).
PLaY
footswitches to select
LED is lit, you have
status LEDs will
Rec/PLaY/
footswitch to
teMPo/stoP
PLaY