Installation - Honeywell TE923W - Deluxe Weather Station User Manual

Required for installation (not included)
- Phillips screwdriver
- Mounting pole for anemometer (optional)
- Small paper clip for reset

Installation

The Honeywell Professional Weather Station TE923W operates at 433MHz radio frequency, so no
wire installation is required between the main unit (receiver) and the remote weather sensors
(transmitters).
The remote weather sensors include a thermo-hygrometer (temperature and humidity) sensor, UV
(ultraviolet) sensor, anemometer (wind sensor) and a rain gauge (rain sensor). All data measured
by these remote sensors is transmitted to the main unit wirelessly, with the operating range up to
328 feet (100 meters) in the open area.
Remote UV sensor, anemometer and a rain gauge must be placed outdoors to measure weather
elements.
Remote thermo-hygrometers can be placed indoors or outdoors, depending on the area where the
temperature and humidity are intended to be measured. If you intend measuring outdoor
temperature and humidity, place the remote sensor outdoors.
Note: It is critical to assemble and power up all of the remote weather sensors BEFORE setting
up the main unit.
Note: It is critical to power up and test communication between all of the weather sensors and the
main unit BEFORE permanently mounting them outside.
5
TE923W IM1(ENG) HONEYWELL R.pmd 5 4/11/08, 5:24 PM