•
During an initial setup, place the main unit close to the remote anemometer.
•
After reception is established (the wind readings will appear on the main unit's
display), position the remote anemometer and the main unit within the effective
transmission range of 100 feet (30 meters). Ideally it should be placed within the
line of sight of the main unit. Transmission range may be affected by trees,
metal structures and electronic appliances.
•
The effective operating range may be influenced by the surrounding building
materials and how the receiver (main unit) and transmitter (remote anemometer)
are positioned.
IMPORTANT: Make sure that the remote anemometer is accessible for cleaning and
maintenance.
Installation
The Honeywell Remote Anemometer TS805 operates at 433MHz radio frequency, so no
wire installation is required between the main unit (receiver) and the remote anemometer
(transmitter).
All data measured by the remote anemometer is transmitted to the main unit wirelessly,
with the operating range of 100 feet (30meters) in the open area.
Remote anemometer must be placed outdoors to measure wind speed and wind direction.
Note: It is critical to power up and test communication between the anemometer and the
main unit BEFORE permanently mounting it outside.
To install the remote anemometer, you must assemble it first.
Assembly
•
Place the wind cups over the wind cups shaft of the anemometer arm
•
Insert the wrench tool provided into the wind cups opening and tighten the small
screw inside.
•
Test if the wind cups sit secure on the wind cups shaft
Battery installation
•
Remove four (4) screws from the battery compartment with a small Phillips
screwdriver.
•
Open the battery compartment and install 2 "AA" size alkaline batteries (not
included) matching the polarities shown.
•
Replace the battery compartment door and secure the screws.
Aligning
•
Point the wind direction vane to the north (use a compass or map if necessary).
•
Press "SET" opening located inside battery compartment with a paper clip or
similar tool. The "SET" opening controls toggling the wind direction between
the factory preset or user set.
5