Rain Mode - Honeywell TE923W - Deluxe Weather Station User Manual

Remote Sensor Status
The wave icon above the current channel display shows the connection status of the corresponding
remote sensor:
Icon
All Remote Sensor Signals Search Activation
The main unit can be manually activated to search for the signals from all remote sensors.
Press and hold the DOWN button to enable the search.

Rain Mode

The main unit records the total amount of the rainfall for the last hour, 24 hours, past day, past
week and the past month. The rainfall can be displayed in mm or inches.
There is a daily rainfall alert that can be programmed in the unit if the daily rainfall exceeds a pre-
programmed limit.
Accessing Rain Mode
Press main unit UP or DOWN until the RAIN icon
From the remote control: Press
Viewing Rain Statistics
In the Rain Mode, press either SET or MEMORY button to recall a rain statistics for the past
hour, past 24 hours, yesterday, past week or past month.
Tip: For the rain rate, estimate the Last Hour rainfall value is understood as "inch/hr" or "mm/hr".
Resetting the Rainfall Statistics Memory
In the Rain Mode, press and hold the MEMORY button to reset all rainfall statistics.
Setting Units for the Rain Display in inches or mm
In the Rain Mode, press and hold the SET button to toggle rainfall data units between mm and inches.
Enabling or Disabling the Daily Rainfall Alert
• In the Rain Mode press the ALARM/CHART button to display either the current rainfall
statistics or the daily rainfall alert with "ALARM HI" displayed.
• If the alert is disabled, the "OFF" will be displayed; otherwise the rainfall alert value will be
shown.
• When the rainfall alert is displayed, press the UP or DOWN to enable or disable it.
TE923W IM1(ENG) HONEYWELL R.pmd
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 15 minutes
.
32
32
Status
on the display starts flashing.
4/11/08, 5:28 PM