Rain Mode - Honeywell TE821W User Manual

Resetting the Remote Temperature and Humidity Memory
In the Temperature and Humidity Mode, press and hold MEMORY button to clear memory for all
channels.
Remote Sensor Status
The wave icon above the current channel display shows the connection status of the corresponding
remote sensor:
Icon
All Remote Sensor Signals Search Activation
The main unit can be manually activated to search for the signals from all remote sensors.
Press and hold DOWN button to enable the search.

RAIN MODE

The main unit records the total amount of the rainfall for the last hour, 24 hours, past day, past week
and the past month. The rainfall can be displayed in mm or inches.
There is a daily rainfall alert that can be programmed in the unit if the daily rainfall exceeds a
pre-programmed limit.
Accessing Rain Mode
From the main unit: Press UP
Viewing Rain Statistics
In the Rain Mode, press either SET or MEMORY button to recall a rain statistics for the past hour,
past 24 hours, yesterday, past week or past month.
TIP: For the rain rate estimate the Last Hour rainfall value is understood as "inch/hr" or "mm/hr".
Resetting the Rainfall Statistics Memory
In the Rain Mode, press and hold MEMORY to reset all rainfall statistics.
Setting Units for the Rain Display in inches or mm
In the Rain Mode, press and hold SET button to toggle rainfall data units between mm and inches.
Enabling or Disabling the Daily Rainfall Alert
• In the Rain Mode press the ALARM/CHART to display either the current rainfall statistics
or the daily rainfall alert with "ALARM HI" displayed.
• If the alert is disabled, the "OFF" will be displayed; otherwise the rainfall alert value will be shown.
• When the rainfall alert is displayed, press the UP
Status
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 15 minutes
or DOWN until the RAIN icon
21
on the display starts flashing.
or DOWN to enable or disable it.