Connecting Your Modem Router - NETGEAR DGND3300 - RangeMax Dual Band Wireless-N DSL Gateway Wireless Router Setup Manual

Connecting Your Modem Router

Before you install your modem router, make sure that the Internet Protocol (TCP/IP) Property
settings on your computer are set to "automatically obtain an IP address" using DHCP and "Obtain
DNS server address automatically." You can check these settings by looking at the TCP/IP
Properties of your Internal Network Connections, which are accessible through the Control Panel
of your computer. If you are unsure about this, refer to the documentation for your computer or see
the link to TCP/IP Addressing in
If you are replacing an existing router, disconnect it completely from your network
and set it aside before starting to install your new router.
To connect the modem router, the ADSL filter and the computer:
1. Connect an ADSL filter as shown below.
If you purchased the modem router in a country where an ADSL filter is not
included, you must acquire one.
• Install an ADSL filter for every telephone that uses the same phone line as your modem
router. Select the appropriate filter(s) for your wireless setup.
1
3
1. One-Line filter: Use with a phone or fax machine.
2. Splitter: Use with a one-line filter to share an outlet with a phone and the modem router
3. Two-Line filter with splitter: Use to share an outlet with a phone and the modem router
Figure 8
Installing Your Router Manually (Advanced, Mac, and Linux Users)
"Related Documents" on page
2
41.
.
.
15