Connecting Your Wireless Modem Router - NETGEAR DG834Gv5 Setup Manual

Connecting Your Wireless Modem Router

Before you install your wireless modem router, make sure that the Internet Protocol (TCP/IP)
Property settings on your computer are set to "automatically obtain an IP address" using DHCP
and "Obtain DNS server address automatically." You can check these settings by looking at the
TCP/IP Properties of your Internal Network Connections, which are accessible through the
Control Panel of your computer. If you are unsure about this, refer to the documentation for your
computer or see the link to TCP/IP Addressing in
If you are replacing an existing router, disconnect it completely from your network
and set it aside before starting to install your new router.
To connect the wireless modem router, the ADSL filter and the computer:
1. Connect an ADSL filter as shown below.
If you purchased the DG834G in a country where an ADSL filter is not included,
you must acquire one.
You must install an ADSL filter for every telephone that uses the same phone line as your
wireless modem router
a. Select the filter and splitter that you need based on the type of phone line at your location.
1
3
Figure 7
Installing Your Router Manually (Advanced, Mac, and Linux Users)
"Related Documents" on page
2
1 One-Line Filter. Use with a phone or fax machine.
2 Splitter. Use with a one-line filter to share an outlet
with a phone and the modem router
3 Two-line filter with splitter. Use to share an outlet
with a phone and the modem router
37.
.
.
13