Power Led Is Off; Power Led Is Red; Lan Leds Are Off - NETGEAR DGND3300 - RangeMax Dual Band Wireless-N DSL Gateway Wireless Router Setup Manual

• The ADSL link LED is lit, indicating that a link has been established to the connected
device.
• The Wireless LEDs are lit.
If any of these conditions does not occur, refer to the appropriate following section.

Power LED Is Off

If the Power and other LEDs are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
• Check that you are using the power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.

Power LED Is Red

When the router is turned on, it performs a power-on self test. If the Power LED turns red after a
few seconds or at any other time during normal operation, there is a fault within the router. The
power LED also turns red when you depress the factory default reset push button, and blinks red 3
times when that button is released. However, in this case, the modem router is working normally.
If the power LED turns red to indicate a router fault:
• Cycle the power to see if the router recovers.
If the power LED is still red one minute after power up:
• Cycle the power to see if the router recovers.
• Clear the router's configuration to factory defaults. This will set the router's IP address to
192.168.0.1. This procedure is explained in
page 37.
If the error persists, you might have a hardware problem and should contact technical support.

LAN LEDs Are Off

If the LAN LEDs do not light when the Ethernet connection is made, check the following:
• Make sure that the Ethernet cable connections are secure at the router and at the hub or
workstation.
• Make sure that power is turned on to the connected hub or workstation.
Troubleshooting
"Using the Restore Factory Settings Button" on
30