Table of Contents
Advertisement
Figure 3-12 Install the device using front and rear mounting brackets (3)
(1) Front square-holed bracket
Installing the Device Using Front Mounting Brackets and a Tray
The tray is an optional component that needs to be separately ordered if needed.
Follow these steps to install the device (take the WX3024 as example) in a rack using front mounting
brackets and a tray:
Step1 Put on an ESD-preventive wrist strap and check that the rack is sturdy and properly grounded.
Step2 As shown in Figure 3-7, use the screws packed with the front mounting brackets to fix the front mounting
brackets on both sides of the device.
Step3 Fix the tray on the rack as shown in Figure 3-13 (this figure is for reference only and may differ from the
actual installation on your rack).
(1)
(2)
(2) Front mounting bracket
3-8
Advertisement
Table of Contents
