Terminal Or Pc; Chassis Rack Installation; Front Rack Mounting - 3Com 6200 Hardware And Software Users Manual

Installation
Chassis Rack
Installation
Front Rack
Mounting
3COM Security Switch 6200 Hardware and Software Users Guide

Terminal or PC

A VT-100 terminal or a Personal Computer (PC) is required during
installation. The terminal or PC is connected to the chassis's craft port,
allowing you to monitor start-up diagnostics and to configure the unit for
remote management access.
The chassis can be installed in the front or center of a standard 19" rack.
To install the chassis in the front of your rack:
1. Remove the center brackets (one on each side) from the system.
2. Position the chassis in the rack by aligning the holes on its integrated
front mounting brackets with the holes in the rack.
3. Insert the appropriate screws through the brackets and tighten. If
the rack holes are not threaded, use cage-nuts over them. Figure 2-2
shows a chassis installation example.
Figure 2-2 Front Rack Mounting the Chassis
Front
Mounting
Bracket
Rear
Mounting
Bracket
2-5