Connecting The Rps Cable - 3Com WX3008 AC POE 8GET Installation Manual

Connecting the RPS Cable

The WX3010 and WX3008 do not support RPS.
Follow these steps to connect the RPS cable:
Step1 Check that the device is powered off and the RPS unit is switched off.
Step2 Use a Philips screwdriver to remove the screws on the cover on the DC power receptacle and take off
the cover.
Step3 Connect the RPS cable to the DC power receptacle on the chassis.
Step4 Turn the strain release screws on the RPS cable clockwise so that the RPS cable plug is firmly seated in
the DC power receptacle, and then fasten the strain release screws.
Step5 Connect the other end of the RPS cable to an output interface of the RPS unit.
Figure 3-28 Connect the RPS cable
(1) DC power receptacle
(3) RPS cable
(5) RPS unit
(7) AC power input interfaces of the RPS unit
Step6 Check the RPS LED on the front panel of the device. LED ON means the RPS unit is correctly
connected.
The RPS unit is an optional accessory. The WX3024 supports the RPS1000.
Check that the ground cable is properly connected before powering on the device.
(7)
(1) (2)
(3)
3-19
(5)
(6)
(4)
(2) RPS cable plug for the DC power receptacle
(4) RPS cable plug for the RPS output
(6) Output interfaces of the RPS unit