Installation Manual
H3C S5500-EI Series Ethernet Switches
Figure 4-6 Set terminal emulation in properties setting window
4.4 Booting the Switch
4.4.1 Checking before Power-On
Before powering on the switch, verify that:
The power cable and grounding cable are properly connected.
The power supply voltage is consistent with that required by the switch.
The console cable is properly connected; the terminal (which can be a PC) used
for configuration has been started; and the configuration parameters have been
set.
4.4.2 Powering On the Switch
The S5500-EI series have the same Boot ROM display style. This document uses the
Boot ROM display of S5500-28F-EI as an example:
4-5
Chapter 4 Initial Power-On