Connection Procedure; Installing And Removing Optional Interface Modules - H3C S5500-28C-EI Installation Manual

Installation Manual
H3C S5500-EI Series Ethernet Switches
RJ-45
7
8

3.4.2 Connection Procedure

When you want to use the terminal to configure the switch, follow these steps to
connect a terminal device to the switch using the console cable:
1) Plug the DB-9 female connector of the console cable to the serial port of the PC or
terminal where the switch is to be configured.
2) Connect the RJ-45 connector of the console cable to the console port of the
switch.
Caution:
Pay attention to the mark on the console port and be sure to plug the connector to the
right port.
Note:
When connecting a PC to a powered-on switch, you are recommended to connect
the DB-9 connector of the console cable to the PC before connecting the RJ-45
connector to the switch.
When disconnecting a PC from a powered-on switch, you are recommended to
disconnect the DB-9 connector of the console cable from the PC after disconnecting
the RJ-45 connector from the switch.

3.5 Installing and Removing Optional Interface Modules

The S5500-EI series provide two 10 GE extended module slots on the rear panel. You
can select the following extended modules:
One-port 10 GE XFP interface module
Dual-port 10 GE XFP interface module
Short-haul dual-port 10 GE CX4 interface modules
Signal Direction
←
DSR
←
CTS
3-20
Chapter 3 Installation
DB9(MODEM) DB9(CONSOLE)
6 4
8 7