Installation Manual
H3C S5500-EI Series Ethernet Switches
Note:
Guide rails are optional parts. Check Table 3-1 to see whether you need to order them
or not.
3.1.3 Using Front Mounting Ears to Install the Switch
Follow these steps to install the switch into a 19-inch standard cabinet:
1)
Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
2)
Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in Figure 3-4.
Figure 3-4 Fix front mounting ears (1)
3)
Place the switch horizontally in a proper position, and fix the other end of mounting
ears to the front brackets with screws and captive nuts, as shown in Figure 3-5.
3-4
Chapter 3 Installation
Front panel