Using Front Mounting Ears And A Tray; Using Front And Rear Mounting Ears - H3C S5500-28C-EI Installation Manual

Installation Manual
H3C S5500-EI Series Ethernet Switches
Figure 3-5 Fix front mounting ears (2)

3.1.4 Using Front Mounting Ears and a Tray

Follow these steps to install the switch into a 19-inch standard cabinet:
1) Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
2) Fix the delivered tray horizontally in a proper position.
3) Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in Figure 3-4.
4) Place the switch on the tray horizontally, slide the tray into the cabinet, and fix the
other end of mounting ears to the front brackets with crews and captive nuts, as
shown in Figure 3-5.

3.1.5 Using Front and Rear Mounting Ears

Follow these steps to install the switch into a 19-inch standard cabinet:
1) Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
2) Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in Figure 3-4.
3) Take out the load-bearing screws (packed together with the rear mounting ears)
and place them in a proper position on the sides of the switch, as shown in Figure
3-6.
Front square-holed bracket Front square-holed bracket
Front Front
mounting ear mounting ear
3-5
Chapter 3 Installation
Front mounting ear Front mounting ear
Front panel Front panel