Short-Haul Dual-Port 10 Ge Cx4 Interface Module - H3C S5500-28C-EI Installation Manual

Installation Manual
H3C S5500-EI Series Ethernet Switches
2) Loosen the fastening screws at both sides of the XFP interface module using a
Phillips screwdriver.
3) Pull the XFP interface module towards you, until it completely comes out of the
switch chassis.
Caution:
When installing or removing an optional interface module, pay attention to the following
points:
Do not exert a great force on the interface module, and do not touch the
surface-mounted components directly with your hands.
After removing an optional interface module, if no new module is to be installed,
install the blank panel as soon as possible to prevent dust and ensure the normal
ventilation in the switch.

3.5.2 Short-haul Dual-port 10 GE CX4 Interface Module

I. Appearance and front panel of a short-haul dual-port 10 GE CX4 interface
module
Figure 3-36 Appearance of a short-haul dual-port 10 GE CX4 interface module
Figure 3-37 Front panel of a short-haul dual-port 10 GE CX4 interface module
3-23
Chapter 3 Installation