Installation Manual
H3C S5500-EI Series Ethernet Switches
For detailed information, please refer to H3C S5500-EI series Ethernet Swtiches
GE/10G Interface Module Installation Guide.
1.10.1 Description of LEDs on Extended Modules
There is a LED for each extended module slot. Table 1-9 describes the LED.
Table 1-9 Description of the LED for each extended module slot
LED
LED
extended
module slot
1.11 CX4 Cable
You can use a CX4 cable to connect the CX4 port on the rear panel of the S5500-EI
series to another CX4 port.
Figure 1-19 CX4 cable
The following three types of CX4 cables are available:
50 cm (19.7 in.): The connectors at both ends of the cable are bayonet connectors.
100 cm (39.4 in.): The connectors at both ends of the cable are bayonet
connectors.
300 cm (118.1 in.): The connectors at both ends of the cable are bayonet
connectors.
Mark
This LED is
for
not
—
affected by
the
button.
1-30
Status
The
normal. The LED flashes at
Green
a high frequency when the
port is sending or receiving
Mode
data.
OFF
The port is not connected.
Chapter 1 Product Overview
Description
port
connection
is