Acro/Heli Model Type Select Function; Trnr Trainer Function - FUTABA 6EX-2.4GHZ Instruction Manual

ACRO/HELI Model type select function

The Model type select function is used to select the ACRO or HELI mode of model type.
ACRO: Powered aircraft memory type (with multiple wing and tail configurations. See Wing mixing type selection for further
information, p20.)
HELI: Helicopter memory type (with three helicopter swashplate type. See Swashplate types selection for further information,
p28.)
CAUTION: Before doing anything else to set up your aircraft, first you must decide Model type (include wing mixing type or
swashplate type) best fits this particular aircraft.
To select model type:
1. Access the Model Select function in the programming mode (by pressing the MODE and
SELECT keys simultaneously and holding them down for one second). To select the model
memory, select model type, press the DATA INPUT lever, and hold it down for 0.5 seconds
until the desired model number appears.
2. Push SELECT key twice after seeing on the screen the model memory where you want to
select model type. Then you will see "ACRO" and "HL" or "HELI" and "AC" on the screen.
3. To change model type, push the DATA INPUT lever and hold it down for about two seconds.
"HL" and "AC" blinks first, and then it stops blinking with a sound. The current model type
"ACRO" or "HELI" is displayed.
TRNR Trainer function (ACRO only)
The Trainer function is used to activate the trainer switch in each model memory as the
instructors' transmitter. See Trainer switch for further information, p33.
To activate trainer function:
1. Access the Model Select function in the programming mode (by pressing the MODE and
SELECT keys simultaneously and holding them down for one second). To select the model
memory which you wish to activate trainer function, press the DATA INPUT lever and hold it
down for 0.5 seconds until the desired model number appears.
2. Push SELECT key three times after seeing on the screen the model memory where you
want to activate trainer function. Then you will see "TRNR" on the screen.
3. To activate the function, push the DATA INPUT lever up for 0.5 seconds. The "ON" is
displayed. To inhibit the function, push the DATA INPUT lever down for 0.5 seconds. The
"INH" is displayed.
15