V-Tl V-Tail Mixing - FUTABA 6EX-2.4GHZ Instruction Manual

To activate flap trim:
1. Enter the programming mode. Access the "FLTR" screen with the MODE key.
2. If "INH" is blinking, push DATA INPUT lever upward for 0.5 seconds. Then you will see that
the blinking "INH" changes to "ON". Your flap trim is now turned on.
3. Set the travel of the flap switch at between -100% and +100% by using DATA INPUT lever.
Two rates (upward and downward of flap switch) are adjustable.
V-TL V-tail mixing (ACRO only)
Intended for V-tail aircraft (such as a Beechcraft Bonanza), V-tail mixing allows
the ruddervators to operate both as rudders and elevators. The same as the other
mixes, V -tail mixing requires that each ruddervator be operated by a separate
servo.
To activate V-tail mixing:
1. Connect the left ruddervator servo to channel 2 (elevator) in the receiver and connect the
right ruddervator servo to channel 4 (rudder) in the receiver.
2. Enter the programming mode. Access the "V-TL" screen with the MODE key.
You cannot set "V-tail" mixing when "Elevon" mixing has already been set. In order to enable
"V-tail" mixing, you first need to cancel "Elevon" mixing. However, it is allowed to use "V-Tail"
and "Flaperon" mixing simultaneously.
3. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing "INH"
display to change to a flashing "ON" display. Now the mixing is on.
*If necessary, use the Servo Reversing
function to achieve the correct direction of
servo throws.
21