Installing Dti-520Ub On A Mount Arm - Wacom DTI-520UB User Manual

Installing DTI-520UB on a Mount Arm

This product conforms to the Video Electronics Standard Association's (VESA) Flat Panel Monitor
Physical Mounting Interface Standard (FPMPMI).
This product can be removed from the stand and mounted on such apparatuses as a VESA-
standard mount arm. In order to do this, M4/0.7 mm screws, which are not included with the
product, are needed. Use screws that will, at the time of installation, penetrate the surface of the
product by no more than 15 mm. Use of longer screws may result in damage to internal parts of
the product.
1
Make sure that both your computer and the
product are turned off and that all cables are
disconnected.
2
Place the display unit face down on a flat
surface. To prevent harm to the front of the
unit, first spread a cloth or other similar
material on the flat surface.
3
Remove the four screws that hold the stand
to the unit.
4
Using four M4/0.7mm screws, securely mount
the arm or similar apparatus to the back of the unit.
Caution
When installing the unit on a mount arm or
other stand, always follow the directions in
the instruction booklet for the mount arm or
stand, as well as the instructions contained
in this document. Incorrect installation may
result in the product coming loose and falling
and possibly causing product failure.
5
Connect the cables and save the screws that you
removed in step 3.
8
Unscrew