Using An Alternate Mount Or Stand - Wacom Cintiq 22HD User Manual

USING AN ALTERNATE MOUNT OR STAND

If using Cintiq in an installation that requires the use of an alternate mounting platform, you can mount the
pen display onto any stand or mounting platform conforming to the VESA MIS-D 100/100 (4 screw)
standard.
Notes:
Required mounting screws are 4 mm wide with a 0.7 mm pitch (M4 Regular). The pen display screw
holes depth is 12 mm. Exceeding the clearance depth will damage the internal components of the
pen display.
Any platform or fixture on which Cintiq is mounted must be able to support the weight of the
interactive pen display.
To attach the pen display to a VESA mount:
1. Turn off your computer and power off Cintiq. Then disconnect all cables from between the pen display
and your computer.
2. Remove Cintiq from the display
a cloth spread across a desktop).
3. Remove the bearing hub by unscrewing the four bearing hub attachment screws. Carefully separate the
bearing halves and remove the bearing stopper to free up the cabling. Take care not to lose the small
bearing stopper found within the inner groove of one of the hub sections.
Rear cover
Cable channel
Bearing stopper
Bearing hub sections
(removed) and
attachment screws
Contents Index
stand. Place the pen display face down on a flat, soft surface (such as
Contents Index
• Remove screws from rear
cover and lift cover away
from the pen display.
• Thread cables through the
cable channel and reattach
the rear cover, making sure
to use the correct screws.
The rear cover screws are
shorter than the bearing
hub screws.
91
91