Installing Dtf-521 On A Mount Arm - Wacom DTF-521 User Manual

Component Functions

Installing DTF-521 on a Mount Arm

This product conforms to the Video Electronics Standard Association's (VESA) Flat Panel Monitor
Physical Mounting Interface Standard (FPMPMI).
This product can be removed from the stand and mounted on such apparatuses as a VESA-standard
mount arm. In order to do this, M4/0.7 mm screws, which are not included with the product, are
needed. Use screws that will, at the time of installation, penetrate the surface of the product by no
more than 15 mm. Use of longer screws may result in damage to internal parts of the product.
1
Make sure that both your computer and the product are turned off and that all cables are disconnected.
2
Place the display unit face down on a flat surface.
To prevent harm to the front of the unit, first
spread a cloth or other similar material on the flat
surface.
3
Remove the four screws that hold the stand to
the unit.
4
Using four M4/0.7mm screws, securely mount
the arm or similar apparatus to the back of the
unit.
Caution
When installing the unit on a mount arm or
other stand, always follow the directions in
the instruction booklet for the mount arm or
stand, as well as the instructions contained
in this document. Incorrect installation may
result in the product coming loose and falling
and possibly causing product failure.
5
Connect the cables and save the screws that you
removed in step 3.
8
Unscrew