Industry Canada Required User Information For Cisco Aironet 1000 Series Lightweight Access Points; Safety Considerations - Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual

•
Generally, the 5150-5350 MHz, 5470-5750 MHz, and 2400-2483.5 MHz bands are allowed in most EU
countries. However, there are several country specific restrictions that apply to different bands on a
country-by-country basis.
The following entries specify countries with specific restrictions:
Note These restrictions may evolve. It is recommended that you check with their local authorities for latest
requirements
•
•
•
•
•
•
•
Industry Canada Required User Information for Cisco Aironet 1000 Series
Lightweight Access Points

Industry Canada Required User Information for Cisco Aironet 1000 Series Lightweight Access Points

This device has been designed to operate with antennae having maximum gains of 7.8 dBi (2.4 GHz) and
7.4 dBi (5 GHz).
Antennae having higher gains is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.

Safety Considerations

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
Warning
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
Safety Considerations
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
A-6
The Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access point meets EU DFS
requirement.
Austria - Only transmission within the frequency band 5150-5250 MHz is allowed. The band
5470-5750 MHz is not allowed.
Belgium - The frequency band 5470-5750 MHz is not allowed.
France - The frequency band 5470-5750 MHz is not allowed.
Portugal - Integral antenna is required.
Switzerland - The frequency band 5470-5750 MHz is not allowed.
Czech - The frequency band 5470-5750 MHz is not allowed.
Slovak Republic - The frequency band 5470-5750 MHz is not allowed.
Appendix A Planning Notes
78-17147-01