Collecting Required Tools And Supplies - Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual

Collecting Required Tools and Supplies

Collecting Required Tools and Supplies
This section describes the tools and information that you should have before installing the access point.
•
•
•
•
•
•
•
•
•
Continue with
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
One Cisco Aironet 1000 Series lightweight access point per location.
Cisco Aironet 1000 Series lightweight access point Mounting Kits, factory-supplied with each Cisco
Aironet 1000 Series lightweight access point.
Optional Cisco Aironet 1000 Series lightweight access point Mounting Kits, factory-orderable.
Optional AC-to-DC external power supplies, factory-orderable. Note that this option requires the
power cable to be run through the plenum in a metal conduit to meet safety requirements.
Map showing Cisco Aironet 1000 Series lightweight access point locations and mounting and power
options.
Screwdrivers, drills, and ladder.
An assortment of sheet metal and drywall screws and toggle bolts.
CAT-5 (or higher) cables to connect the Cisco Aironet 1000 Series lightweight access point locations
and other network devices.
Optional Kensington MicroSaver Security Cable to secure each Cisco Aironet 1000 Series
lightweight access point.
"Pre-Installation Configuration.
Installation and Configuration
4