Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual page 23

Installation and Configuration
Figure 7
A. Projection-mount bracket
2. If necessary, drill holes for the various cables where they can be mostly hidden from casual view.
When you are mounting the Cisco Aironet 1000 Series lightweight access point using an optional
orderable projection-mount L-bracket (the one with two long legs), the cables can be routed through
the 5/8-in. (15.9 mm) holes in the bracket.
Route the CAT-5, optional power supply, optional external antenna cable(s), and optional
3.
Kensington MicroSaver Security cables to where they can plug into the Cisco Aironet 1000 Series
lightweight access point. Be sure to leave about 6 in. (15 cm) of slack in the cables for future
modifications.
Attach the brackets to the wall or ceiling, or install screws for ceiling-mount base:
4.
–
–
You are now ready to install the Cisco Aironet 1000 Series 802.11a/b/g lightweight access points.
Continue with
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Factory-Orderable Mounting Brackets
Where you are going to use the projection-mount or flush-mount bracket, use customer-supplied
sheet metal, drywall, or other screws to attach the bracket to the ceiling or wall.
Where you are going to use the ceiling-mount base, install customer-supplied sheet metal,
drywall, or other screws with 1/4 in. (6.35 mm) or smaller heads protruding from the ceiling
about 0.1 in. (2.5 mm).
"Mounting the Cisco Aironet 1000 Series Lightweight Access
B. Flush-mount bracket
Preparing Mounting Locations
Points."
13