Ceiling-Mount Clips - Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual

Mounting the Cisco Aironet 1000 Series Lightweight Access Points

Ceiling-Mount Clips

When you are mounting the Cisco Aironet 1000 Series lightweight access point on the extruded
aluminium rails of a hanging ceiling, use the ceiling-mount clips to mount the Cisco Aironet 1000 Series
lightweight access point as shown in the following figure and as described below:
Figure 9
1.
2.
3.
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Assembling the Cisco Aironet 1000 Series Lightweight Access Point and
Ceiling-Mount Clips
Copy the MAC address(es) from the label(s) on the Cisco Aironet 1000 Series lightweight access
point onto the corresponding location on the map. MAC addresses have the format 00xxxxxxxxxx.
Attach the ceiling-mount clips to the bottom of the Cisco Aironet 1000 Series lightweight access
point using the factory-supplied machine screws and washers.
Snap the ceiling-mount clips onto a hanging ceiling rail.
Installation and Configuration
16