Projection Wall Mount - Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual

Mounting the Cisco Aironet 1000 Series Lightweight Access Points

Projection Wall Mount

When you are mounting the Cisco Aironet 1000 Series lightweight access point out from a wall (flat
sides along the wall or hallway), use an optional separately orderable factory-orderable
projection-mount L-bracket.
1.
The Cisco Aironet 1000 Series lightweight access point threaded holes have precision-depth threads. Do
Note
not overtighten the screws, or the bracket will not fit under the screw heads.
Figure 11
2.
3.
4.
Note If the screws do not securely hold the bracket, remove the Cisco Aironet 1000 Series lightweight access
point and adjust the screws until they securely hold the bracket.
Figure 12
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom
of the Cisco Aironet 1000 Series lightweight access point. Be sure the spring washers have their
convex (high center sections) pointing toward the screw heads.
Attaching the Mounting Screws and Spring Washers to the Cisco Aironet 1000 Series
Lightweight Access Point
A. Screws and spring washers
Copy the MAC address(es) from the label(s) on the Cisco Aironet 1000 Series lightweight access
point onto the corresponding location on the map. MAC addresses have the format 00xxxxxxxxxx.
You have already attached the projection-mount L-bracket to the wall in
Locations."
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Attaching the Cisco Aironet 1000 Series Lightweight Access Point to the
Projection-Mount Bracket
Installation and Configuration
B. Completed assembly
"Preparing Mounting
18