Mounting The Access Point Using A Projection Wall Mount Bracket - Cisco ASR1001 Hardware Installation Manual

Chapter 2 Installing the Access Point

Mounting the Access Point Using a Projection Wall Mount Bracket

When you are mounting the access point out from a vertical wall (flat sides along the wall or hallway),
use an optional factory-orderable projection-mount L-bracket (see
attach the access point to the projection-mount bracket and mount the access point to a vertical wall:
Step 1 Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of
the access point (see
pointing toward the screw heads.
Note
Figure 2-10
Copy the MAC address(es) from the label(s) on the access point onto the corresponding location on the
Step 2
access point location map. MAC addresses have the format 00xxxxxxxxxx.
Find the required mounting location as identified on your access point location map.
Step 3
Step 4 Use the projection-mount bracket to mark the four screw holes on the wall. Ensure to leave enough space
around the access point and base to plug the CAT-5 cable, optional external antenna cable(s), optional
power supply cable, and optional Kensington MicroSaver security cable into the sides of the access
point.
Mount the projection-bracket to the wall using four screws in the marked locations. Use appropriate
Step 5
screws and wall anchors (user supplied). Tighten the wall screws.
Position the two screws in the base of the access point over the projection-bracket keyhole slots and slide
Step 6
the access point in the direction of the key slots (see
point to the bracket, remove the access point and loosen the two access point screws.
Note
OL-9403-04
Figure 2-10). Ensure the spring washers have their convex (high center sections)
Do not tighten the screw heads flush with the access point surface or the bracket will not fit under
the screw heads.
Attaching the Mounting Screws to the Access Point
A. Screws and spring washers
After attaching the access point to the bracket, tighten the screws until they securely hold the
access point.
Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide
Figure 2-6). Follow these steps to
B. Completed assembly
Figure 2-11). If you are unable to attach the access
Mounting Overview
2-13