Installing The Integrated Customer Display; Installing The Magnetic Stripe Reader (Msr) - IBM 4851 514 Planning, Installation And Service Manual

Updated October, 2008
Figure 6. Installing the magnetic stripe reader (MSR)
4. Route the cable A in groove C and plug the cable connector to the rear
The MSR default baud rate is 19 200 bps, 8 data bits, no parity bit, and 1 stop bit
(19200-8-N-1).

Installing the integrated customer display

Use the steps in this procedure to install the integrated customer display to the
system.
1. Remove the rear cover. See "Rear cover – removing and replacing" on page 61.
2. Remove the rear inner metal cover. See "Rear metal panel cover – removing
3. Remove the top cover. See "Top cover – removing and replacing" on page 70.
panel of the tablet.
and replacing" on page 62.
Installing the IBM SurePOS 500 Model 514
Chapter 2. Installing the IBM SurePOS 500 Model 514
9