Installing The Paper Roll - IBM NetVista Kiosk DBCS Hardware Service Manual

Installing the paper roll

Attention:
1. Establish personal grounding before touching this device. For more information,
Figure 1. Printer caution label
2. Keep your fingers clear of the paper cutter while pressing the paper advance
3. Install the paper roll after you verify that your system is powered-on. See
4. Do not use grade of paper other than that specified for this product. Using an
To install the paper roll, do the following:
1. Set the winding direction of the paper roll so that the temperature-sensitive side
2. Align the core of the paper roll with the movable shaft and insert the paper roll
see "Electrostatic discharge (ESD)" on page 158 of the Hardware Service
Manual.
button or when powering on.
"Powering off the NetVista Kiosk" on page 4 for more information.
inferior grade paper can affect the print quality and the life of the print head and
printer mechanism. The NetVista Kiosk supports the 58-mm, the 80-mm, or the
112-mm thermal printer.
faces up.
all the way into the shaft. After the insertion make sure that:
v the extremity of the movable shaft is visible
v the paper roll is not misaligned with its core
v the paper roll rotates smoothly
The NetVista Kiosk-DBCS Model
5