Attaching The I/O Cables; Routing And Connecting Cables To The Rear Connector Panel - IBM 4851 514 Planning, Installation And Service Manual

Installing the IBM SurePOS 500 Model 514
Figure 10. Installing the antenna enclosure
2. Locate the holes on the top of the display and align the bottom of the
3. See C in Figure 10. Insert the two screws into the back of the
4. Route the cable down through the slot ( D ) provided on the back of the display

Attaching the I/O cables

1. Remove the rear cover as described in "Rear cover – removing and replacing"
2. See Figure 3 on page 5 to view the connectors and for information on routing.
3. Route the cables as instructed in "Routing and connecting cables to the rear

Routing and connecting cables to the rear connector panel

This section explains how to connect cables to the rear connector panel. Use cable
ties if desired. Connect the cables in the lowest row first, then work upwards
connecting any additional cables.
Attention: All cables in the rear should be routed to the right of the AC power
cable, when facing the rear of the machine, as shown in Figure 11 on page 13.
12
SurePOS 500 Model 514
a. See A in Figure 9 on page 11. With the antenna enclosure face down,
place the cable receptacle in the notches provided inside of the enclosure
and route the cable to the end of the unit.
b. Place the wireless adapter into the enclosure and plug into the receptacle.
c. See B in Figure 9 on page 11. Slide the back cover on the antenna
enclosure, ensuring that the cable is not pinched.
antenna-enclosure assembly with these holes.
antenna-enclosure assembly and tighten to fasten the unit to the top of the
display.
and plug the end into one of the USB connectors at the rear of the tablet.
Note: You may need to place the Model 514 display face down on a steady
surface to secure this connection.
on page 61.
Connect the I/O cables.
connector panel."
Updated October, 2008