Connections - Bosch VIPX2 Installation And Operating Manual

EN | 20

Connections

Cameras
You can connect two video sources to the VIP X2. Any cameras and other video
sources that produce a standard PAL or NTSC signal are suitable.
– Connect the cameras or other video sources with a video cable (75 Ohm,
BNC connector) to the BNC Video In 1 and Video In 2 sockets.
– If the video signal is not looped through, termination is performed by a soft-
ware setting if necessary (see Video input, page 46).
Audio connections (audio version only)
The audio version of the VIP X2 has two audio ports for audio line signals as well
as a microphone input and a loudspeaker output.
The audio signals are transmitted two-way and in sync with the video signals.
As a result, you can connect a speaker or door intercom system at the destina-
tion point, for example.
Note
If possible you should use the line ports of the intercom for transmitting au-
dio signals on the intercom systems. The following specifications should
be complied with in all cases.
Line In:
Line Out:
MIC (microphone):
SPK (speaker):
Installation
Impedance 9 kOhm typ., 5.5 V
Impedance 16 Ohm min., 3 V
Impedance 2 kOhm typ., 2.8 V
–20 dB in, supply 2.3 V typ.
Impedance 4 Ohm min., 6 V
power output RMS 1 W
Installation and Operating Manual | VIP X2
max. input voltage
p-p
max. output voltage
p-p
max. input voltage,
p-p
max. output voltage,
p-p
Bosch Security Systems | 2006-12 | V2.5