Wall And Floor Power Drop Requirements - IBM 87302RU Planning And Installation Manual

For recommended ways of providing power sources to BladeCenter T racks, see
"Power connections for Type 8730" on page 65. This section provides diagrams that
show different ways to provide redundant power sources to one or more
BladeCenter T units. These diagrams are based on using IBM NetBAY Enterprise
racks.

Wall and floor power drop requirements

Figure 29 through Figure 33 on page 61 shows ac power connectors that can be
used for attachment of power feeds to the rack PDUs.
Figure 29. Rack PDU — 20-A single phase
Figure 30. Rack PDU — 30-A and 32-A single phase
60
BladeCenter T Types 8720 and 8730: Planning and Installation Guide
Table 18. PDUs for 60-Amp 3-phase ac feeds
Number of BladeCenter T units
1
2
3
4
5
Note: 1300-W power supplies do not ship with the required cable to connect to a 60-A
3-phase feed.
20A
W
G
E
Y
L6-20
CEE7 VII
16A
SABS 164
CEI 23-16
30A
X
G
Y
IEC 309
L6-30P
With 1300-W power supplies
Not supported (see note)
Not supported (see note)
Not supported (see note)
Not supported (see note)
Not supported (see note)
16A
16A
E
IEC 309
13A
16A
E
L N
L
BS 1363/A
32A
16A
N
P
E
SI 32
15A
N P
E
E
N
AS 3112