Table of Contents
Advertisement
Figure 27. Ethernet LEDs
Ethernet link LED
Ethernet activity LED
After you connect the management module to the network, the Ethernet port
connection is configured and enabled in one of the following ways:
v If you have an accessible, active, and configured dynamic host configuration
v If the DHCP server does not respond within two minutes after the port is
If you do not want to use the default static values, you can configure the static IP
address, host name, and subnet mask for the management module through the
Web interface. The default IP address is 192.168.70.125, the default subnet
address is 255.255.255.0, and the default host name is MMxxxxxxxxxxxx, where
xxxxxxxxxxxx is the burned-in medium access control (MAC) address. The MAC
address is on a label on the management module, below the IP reset button.
Note: If the IP configuration is assigned by the DHCP server, the network
If you do not want to use DHCP, configure the static IP address, then disable the
DHCP client.
48
BladeCenter T Types 8720 and 8730: Planning and Installation Guide
2
1
Ethernet link
Ethernet activity
When this green LED is lit, there is an active connection through the port to
the network.
When this green LED is flashing, it indicates that there is activity through
the port over the network link.
protocol (DHCP) server on the network, the host name, IP address, gateway
address, subnet mask, and DNS server IP address are set automatically.
connected, the management module uses the static IP address and subnet
address.
administrator can use the MAC address of the management module network
interface to find out what IP address and host name are assigned.
Alarms
Advertisement
Table of Contents
