Table of Contents
Advertisement
6.Command Specification
0
(MSB)
1
2
DU(0)
3
4
(MSB)
5
6
(MSB)
N
0
(MSB)
1
2
DU(0)
3
4
(MSB)
5
6
(MSB)
N
Note:
If there is no Note data in MIC for the Parameter Code specified in the CDB a Check Condition status will be
1.
returned.
If the CDB allocation length is ZERO a Good status is always returned and there is no data phase.
2.
If the CDB allocation length is non-ZERO and there is data in MIC for the Parameter Code data will be returned
3.
up to the size of the MIC data, as limited by the allocation length. For example, if the CDB allocation length is
0FFh and MIC data size for the Parameter Code is 020h 020h data will returned. If the CDB allocation length
is 010h and the MIC data size for the Parameter Code is 020h only 010h data will be returned.
4.
Length 'n' represents the maximum value for a MIC data size. This will depend on MIC type. Present MIC tape
supports 2Kbytes and 8Kbytes MIC. Less than half of this is available for MIC application data; the rest of MIC
memory is reserved for MIC System data. Future MIC tapes will support larger area for MIC application.
6-34
Parameter Code (0003h)
(User Partition Note for Partition #1)
DS(1)
TSD(0)
ETC(0)
User Data Length
Parameter Code (0002h + N)
(User Partition Note for Partition #N)
DS(1)
TSD(0)
ETC(0)
User Data Length
TMC(00)
Reserved
User Data
TMC(00)
Reserved
User Data
SONY AIT-1 Turbo drive SDX-450V series Ver.1.0
LOG SENSE
(LSB)
LP(1)
Reserved
(LSB)
(LSB)
(LSB)
LP(1)
Reserved
(LSB)
(LSB)
Advertisement
Table of Contents
