Freecom TAPEWARE AIT-450I Manual page 143

REQUEST SENSE
83 89
83 8A
83 97
83 98
83 99
83 9B
83 9C
06h
28 00
29 00
29 80
2A 01
2A 03
2A 05
83 87
07h
27 00
83 0B
08h
00 00
00 05
09h
83 08
83 0B
83 83
0Bh
43 00
45 00
47 00
48 00
4A 00
4B 00
4E 00
SONY AIT-1 Turbo drive SDX-450V series Ver.1.0
User Volume Note Size Mismatch
User Partition Note Size Mismatch
Current Partition is not the last partition
Can not append the new partition, because remaining capacity too short.
Can not delete partition
Can not format tape because real tape capacity is exceeded
Can not append new partitions because the MIC is out of memory
UNIT ATTENTION. Indicates that the removable medium may have been changed or
the target has been reset.
NOT READY TO READY TRANSITION, MEDIUM MAY HAVE CHANGED
POWER ON, RESET, OR BUS DEVICE RESET OCCURRED
Drive Failed Power-on test or Diagnostic - (SONY Unique)
MODE PARAMETERS CHANGED - Issued to all other initiators after one initiator
changes any Mode Parameter.
RESERVATION PREEMPTED(after removing reservation by the CLEAR action)
REGISTRATION PREEMPTED(after removing reservation by the PREEMPT or
PREEMPT ABORT action)
Broken MIC is loaded in AIT mode
DATA PROTECT. Indicates that a WRITE type of operation was attempted on a write
protected tape, write operation is not performed.
WRITE PROTECTED – Cassette is Write Protected.
BROKEN MIC – Cassette is Write Protected
BLANK CHECK. Indicates the drive encountered blank medium or end-of-data
indication while reading.
NO ADDITIONAL SENSE INFORMATION - Blank Tape was encountered at BOT
END-OF-DATA DETECTED - During READ or SPACE command.
Vendor Specific
MIC is not formatted yet
MIC is broken
MIC is exist but is not used
ABORTED COMMAND
MESSAGE ERROR – Unexpected Message phase.
SELECT OR RESELECT FAILURE - SCSI Selection/ Re-selection error.
SCSI PARITY ERROR - SCSI Parity Error detected and drive proceeded to Status
phase.
INITIATOR DETECTED ERROR MESSAGE RECEIVED.
COMMAND PHASE ERROR
DATA PHASE ERROR – Possible DMA error
OVERLAPPED COMMANDS ATTEMPTED - Host issued a new command to the drive
while a previous command was being executed.
6.Command Specification
6-89