Freecom TAPEWARE AIT-450I Manual page 70

6.Command Specification
LP: The LP bit field defines whether the parameter is a data counter or a list parameter. See the description of each
supported page below for information on the setting of this field.
Note: If any of the other bit-fields in the control byte are set then the command will terminate with a CHECK
CONDITION status with a sense key of ILLEGAL REQUEST and an additional sense code of INVALID FIELD IN
PARAMETER LIST
6.6.3. Supported Log Pages
The following log pages are supported:
Page Code
00h Supported Log Pages
02h Write Error Counter Page
03h Read Error Counter Page
07h Last n Error Events Page
30h Tape Log Page (Sony Unique)
31h Tape Capacity Log Page
33h Drive Usage Log Page (Sony Unique)
34h Write Frame Error Counter Page
35h Read Frame Error Counter Page
39h Transfer Log Page
3Ch AIT Log Page
3Dh AIT Fixed Length Information Page for MIC
3Eh AIT Variable Length Information Page for MIC
A description of each supported log page is given below.
6-16
Table 6-10: Threshold Met criteria
TMC Threshold Met Criteria
00b Any update of the parameter
01b Cumulative = Threshold
10b Cumulative < > Threshold
11b Cumulative > Threshold
Table 6-11: Supported Log pages
Description Allocation Length
1A8h (max.)
24h / 404h( 404h –AIT mode)
90h X Partition_number +4
334h – MIC Phase 1
37ch – AIT mode 2k MIC
4a8h – AIT mode 8k MIC
SONY AIT-1 Turbo drive SDX-450V series Ver.1.0
LOG SENSE
12h
20h
20h
5Ch
8Eh
3Ch
4Ch
5Ch
n