Setting The Start/End Points Of The Audio - Yamaha Tyros2 Owner's Manual

Reference
Recording Audio with the Hard Disk Recorder

Setting the Start/End points of the audio

This function (within the Property window) lets you set the Start and End points for the audio
file. This action is non-destructive and affects only the playback of the data; it does not actually
delete any data from the start or end of the file.
1
Select the desired audio file (from the Select display).
2
Press the [PROPERTY] LCD button (upper [7] button).
3
Press the [START/END POINT] LCD button ([H] button).
4
Specify the Start/End point.
The operation of specifying the Start/End points is same as specifying the punch in/out
points. For instructions, see "Specify the recording range in AUTO mode" on page 144.
5
Press the [OK] LCD button ([F] button) to enter the new settings to
the file.
To cancel the operation, press the [CANCEL] LCD button ([G] button).
6
Press the [OK] LCD button ([F] button) to exit from the Property
window.
146
Tyros2 Owner's Manual
NOTE
• When exporting a song for which
the Start/End points have been
specified, only the specified range
will be exported.