Yamaha Tyros2 Owner's Manual page 63

7
Practice the part you want to record and check the levels on the
REC MONITOR meters.
Start the style (see page 31), play the keyboard and sing at the same time. Check that
the level doesn't constantly go into the "red" and light up the indicator. If it does, you
may have to turn the microphone input level down a bit.
Once you're satisfied with the level settings, stop the style.
8
Press the [REC] button to enable recording.
9
Press the [PLAY/PAUSE] button to start recording.
Press the [START/STOP] button in the STYLE CONTROL section or use the Sync
Start function to start the accompaniment. (See page 31.) Play the keyboard and sing
along with your playing.
10
When finished recording, press the [STOP] button.
11
To hear your new recording, press the [PLAY/PAUSE] button.
12
Save the new recording.
Since the recorded data will be erased if another file is selected or the power is turned
off, you'll need to save the recording to the hard disk drive.
To do this, press the [SAVE] LCD button ([I] button), then at the prompt, press the
[OK] LCD button ([G] button).
To select the previous/next audio song
Press the HARD DISK RECORDER [PREV]/[NEXT] button. This only selects the
previous/next song in the same folder level.
Recording Audio to the Tyros2—Hard Disk Recorder
Quick Guide
CAUTION
• Keep in mind that even if you
neglect to save the recorded
data in this step, a file with the
name specified in Step 5 above
will still remain on the hard disk
drive. In other words, the file
exists on the hard disk drive,
but is empty (since it has not
been properly saved). If for
some reason you name and
record a file without saving it,
you may want to delete that
named (but empty) file to avoid
confusion.
NOTE
• The HARD DISK RECORDER
[PREV] [NEXT] buttons cannot be
used when the VOLUME, REC
MODE or START END POINT dis-
play is shown.
63
Tyros2 Owner's Manual