Enabling The Ports And Setting The Ip Addresses - Xerox 4112 System Administration Manual

5. U s i ng t h e S c an S e r v i ce

Enabling the ports and setting the IP addresses

5- 8
In order to use FTP service on the machine, enable the port and
set the IP address.The procedure for setting the machine is as
follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
Refer to "Using CentreWare Internet Services" on page 3-1.
Enter the System Administrator Mode (Chapter 1 Entering the
1.
System Administrator Mode on page 1-15.)
Enable the SNMP port.
2.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select SNMP and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
g. Select Close
Enable the FTP client port and Internet service (HTTP) port as
3.
above.
4. Select Close.
5. If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
6. Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
7. After the machine is restarted, print out the Printer Settings
List to confirm that the ports are enabled and TCP/IP is
configured.
Xe r o x 4112 /4 1 27 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e