Usb Device Setting - EVGA 730i - nForce Motherboard - ATX User Manual

Onboard FDC Controller
Select "Enabled" if you wish to use onboard floppy disk controller (FDC). If
you install an external FDC or the system has no floppy drive, select
"Disabled "in this field.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port. Options
are [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [Auto], and [Disabled].

USB Device Setting

Press Enter
USB 1.0 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Function
USB Mouse Function
USB Storage Function
USB 1.0 Controller
Use this function to enable the USB 1.0 controller.
USB 2.0 Controller
Use this function to enable the USB 2.0 (EHCI) controller.
USB Operation Mode
Select the USB Operation Mode for USB device supports transfer rates.
Options are Full/Low Speed and High Speed (480 Mbps).
USB Keyboard Function
Use this function to enable or disable support for USB keyboard under DOS.
USB Mouse Function
Use this function to enable or disable support for USB Mouse under DOS.
USB Storage Function
Use this function to enable or disable legacy support of USB Mass Storage.
EVGA
46
to display the USB Device Setting menu.
[Enabled]
[Enabled]
[High Speed]
[Enabled]
[Enabled]
[Enabled]