Storage Config - EVGA 730i - nForce Motherboard - ATX User Manual

Storage Config

Press Enter
DMA transfer access
Prefetch Mode
HDD Block Mode
SATA Controller
SATA Operation Mode
SATA SALP Features
JMB363 ATA Controller
JMB363 Mode
DMA transfer access
Use this function to enable or disable DMA transfer access.
Prefetch Mode
Use this function to enable or disable the
HDD Block Mode
Using this function on the Integrated Peripherals menu allows your hard drive
needs to support block mode. Select
optimal number of block read/writes per sector the drive can support. Select
[Disabled]
SATA Controller
This function allows you to enable specific SATA controllers, enable all
controllers, or disable all controllers.
SATA Operation Mode
This is allows you set the onboard Serial SATA mode.
EVGA
44
to display the Storage Config menu.
if your drive does not support block mode.
IDE: Use the Serial ATA hard disk drivers as Parallel ATA storage
devices.
RAID: Create a RAID 0, 1, 0+1, 5 and JBOD configuration.
AHCI: Use the AHCI (Advanced Host Controller Interface) to enables
advanced SATA features for improved performance with NCQ and
Hot-plug features
Linux AHCI: Use the function for Linux AHCI.
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[IDE]
[OFF]
[Enabled]
[IDE]
Prefetch mode
to automatically detect the
[Enabled]
.