Configuration Profile; Dg834G V4 With Fqdn To Fvl328 - NETGEAR DG834Gv4 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual

ADSL2+ Modem Wireless Router DG834G Reference Manual

DG834G v4 with FQDN to FVL328

This section is a case study on how to configure a VPN tunnel from a NETGEAR DG834G v4 to a
FVL328 using a fully qualified domain name (FQDN) to resolve the public address of one or both
routers. This case study follows the VPN Consortium interoperability profile guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html).

Configuration Profile

The configuration in this section follows the addressing and configuration mechanics defined by
the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify that the firmware is up to date, and that you have all the addresses that will be
necessary, and all of the parameters that need to be set on both sides. Check that there are no
firewall restrictions.
Table B-2. Profile Summary
VPN Consortium Scenario:
Type of VPN
Security Scheme:
IP Addressing:
NETGEAR-Gateway A
NETGEAR-Gateway B
10.5.6.0/24
Gateway A
LAN IP
10.5.6.1
DG834G
Figure B-6
B-6
Scenario 1
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
IKE with Preshared Secret/Key (not Certificate-based)
Fully Qualified Domain Name (FQDN)
FDQN
VPNC Example
Network Interface Addressing
WAN IP WAN IP
dg834g.dyndns.org
fvl328.dyndns.org
(FQDN)
v2.0, September 2007
Gateway B
(FQDN)
FVL328
NETGEAR VPN Configuration
172.23.9.0/24
LAN IP
172.23.9.1