Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Dg834G V4 - NETGEAR DG834Gv4 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual

ADSL2+ Modem Wireless Router DG834G Reference Manual
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v4" on page 6-6
describes how to use the VPN Wizard to configure the VPN tunnel between the remote PC and
network gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 6-9
shows how to configure the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G v4
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
Tunnels in Special Circumstances" on page 6-32
The worksheet in Table 6-3
worksheet is at "Planning a
Table 6-3. VPN Tunnel Configuration Worksheet
Connection Name:
Pre-Shared Key:
Secure Association -- Main Mode or Manual Keys:
Perfect Forward Secrecy -- Enabled or Disabled:
Encryption Protocol -- DES or 3DES:
Authentication Protocol -- MD5 or SHA-1:
Diffie-Hellman (DH) Group -- Group 1 or Group 2:
Key Life in seconds:
IKE Life Time in seconds:
VPN Endpoint Local IPSec ID
Client toDG834
DG834G v4 toClient
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
6-6
Table 6-2 on page
identifies the parameters used in the following procedure. A blank
VPN".
LAN IP Address
—
192.168.3.1
v2.0, September 2007
6-4. If you have special requirements
to set up the VPN tunnel.
RoadWarrior
12345678
Main
Disabled
3DES
SHA-1
Group 2
28800
(1 hour)
3600
FQDN or Gateway IP
Subnet Mask (WAN IP Address)
—
255.255.255.0 22.23.24.25
Virtual Private Networking
"Setting Up VPN
(8 hours)
Dynamic